Octoplus Box JTAG Software v.1.7.4 is out!

05.12.14

Octoplus Box JTAG Software v.1.7.4 is out!

We have added boot repair via USB and small TP for LG D320, D320F, D320N, D380, D385, MS323, which are detected by PC as "Qualcomm HS-USB QDloader 9008" device!
Also added repair via JTAG interface for LG C410, ZTE Z993, Samsung GT-B6520!

Octoplus Box JTAG Software v.1.7.4 Release Notes:

Added support for the following models:

  • LG D320 - added Dead Boot Repair via USB
  • LG D320F - added Dead Boot Repair via USB
  • LG D320N - added Dead Boot Repair via USB
  • LG D380 - added Dead Boot / Device Repair via USB
  • LG D385 - added Dead Boot Repair via USB
  • LG MS323 - added Dead Boot Repair via USB
  • LG C410 - added Dead Boot / Device Repair
  • ZTE Z993 - added Dead Boot Repair (thanks to Mr. Dr_Wolodya)
  • Samsung GT-B6520 - added Dead Boot Repair (thanks to Mr. Dr_Wolodya)

To repair mentioned above devices via USB, please follow the next three steps:

  1. Attach testpoint as shown on Figure 1 in the Software manual and connect your phone using Micro USB cable directly into the motherboard’s USB port (do NOT use any USB hubs!)
  2. Check PC Device Manager, a new device should appear "Qualcomm HS-USB QDLoader 9008" or "Unknown Device" if you hadn’t installed the driver yet. Drivers are in {Installation_Folder}\Driver\QHSUSB
  3. Release testpoint and press “EasyRepair” button in the software (or “Connect” button, when in Advanced Mode)

All pinouts and Repair procedures are described in the manual ("Help" button in Software).

Download Octoplus Box JTAG Software v.1.7.4