Octoplus JTAG Software v1.8.7 is out!

03.04.15

Octoplus JTAG Software v1.8.7 is out!

We have added Boot Repair via USB and small TP for LG VS930 and LG F160L and via JTAG for TeXet TM-3200R, Crius Q7A and Huawei G520-0000!

Octoplus Box JTAG Software v.1.8.7 Release Notes:

  • Added support for the following models:
    • LG VS930 - added Dead Boot Repair via USB
    • LG F160L- added Dead Boot Repair via USB
    • TeXet TM-3200R - added Dead Boot / Device Repair via JTAG (thanks to mr. Drunya_L)
    • Crius Q7A- added Dead Boot / Device Repair via JTAG (thanks to mr. DZ_Developer)
    • Huawei G520-0000 - added Dead Boot Repair via JTAG (thanks to mr. Dr_Wolodya)
  • All pinouts and Repair procedures are described in the manual ("Help" button in Software).

To repair LG VS930 and LG F160L via USB, please follow the next three next steps:

  1. Attach testpoint as shown on Figure 1 in the Software manual and connect your phone using Micro USB cable directly into the motherboard’s USB port (do NOT use any USB hubs!)
  2. Check PC Device Manager, a new device should appear "Qualcomm HS-USB QDLoader 9008" or "Unknown Device" if you hadn’t installed the driver yet. Drivers are in {Installation_Folder}\Driver\QHSUSB
  3. Release testpoint and press “EasyRepair” button in the software (or “Connect” button, when in Advanced Mode)

 

Download Octoplus Box JTAG Software v.1.8.7

Go to top of page