Octoplus Box JTAG Software v.1.8.4 is out!

06.03.15

Octoplus Box JTAG Software v.1.8.4 is out!

We have added boot repair (all in Test Mode) via USB and small TP for LG G3 D852, D852G, D855, D855K and D855P.

Octoplus Box JTAG Software v.1.8.4 Release Notes:

  • Added support for the following models:
    • LG D852 - added Dead Boot Repair via USB (Beta)
    • LG D852G - added Dead Boot Repair via USB (Beta)
    • LG D855 - added Dead Boot Repair via USB (Beta)
    • LG D855K - added Dead Boot Repair via USB (Beta)
    • LG D855P - added Dead Boot Repair via USB (Beta)
  • All pinouts and Repair procedures are described in the manual ("Help" button in Software).

To repair mentioned above devices via USB, please follow the next three next steps:

  1. Attach testpoint as shown on Figure 1 in the Software manual and connect your phone using Micro USB cable directly into the motherboard’s USB port (do NOT use any USB hubs!)
  2. Check PC Device Manager, a new device should appear "Qualcomm HS-USB QDLoader 9008" or "Unknown Device" if you hadn’t installed the driver yet. Drivers are in {Installation_Folder}\Driver\QHSUSB
  3. Release testpoint and press “EasyRepair” button in the software (or “Connect” button, when in Advanced Mode)

 

Download Octoplus Box JTAG Software v.1.8.4